Red strobe for mounting in a 12 mm hole

An LED strobe that can be connected to a 12V or 24V power supply and integrated into existing headlights in cars, trucks, and motorcycles. Two bright 3W/5W LEDs create a wide beam of light that spreads across the entire surface of the lamp.

The strobe is mounted in a 12mm diameter hole and secured with double-sided tape along the edges. The tape is already applied to the strobe.

Switch between 21 different programs using the included controller. If multiple strobes are installed, they can be synchronized by connecting the appropriate cables according to the instructions.

Please note that these strobes are NOT ECE R65 approved, only R10 (EMC) approved, and are NOT permitted for use on public roads or highways.

Connection

• White = Synchronization with other Prostrobe devices
• Red = Warning light positive (12V-24V)
• Black = Negative
• Yellow = Flash pattern/programs negative.

Flash Mode Change

Pulsing the yellow wire to the black (negative) wire for less than 1 second cycles through 26 different flash patterns/programs.

Pulsing for 1 to 3 seconds returns the flash pattern/program to the previous flash pattern/program. Pulsing for longer than 5 seconds turns the flash pattern/program off. When the LED light is turned back on, it will continue with the previously selected flash pattern/program.

Technical Specifications:

• Certifications: R10 (EMC)
• Flash Pattern: 26
• Hole Size: 12 mm
• LEDs: 2 x 3 W/5 W
• Temperature: -30 to 60 degrees Celsius
• Voltage: 12 V - 24 V
• Length: 32.0 mm
• Diameter: 25.0 mm